AZ DoR 5000 2021-2024 free printable template

Video instructions and help with filling out and completing az 5000 form

Instructions and Help about arizona form 5000a

Music Applause hi I'm ed Baldwin on an inventor of Z counter form I've been in the construction business for over 30 years when I decided to start pouring concrete countertops I realized there has to be an easier more economical way Z counter form is a brand-new forming system that allows do-it-yourselfer and professionals the ability to pour beautiful cast-in-place countertops with a variety of edge profiles in this instructional video will show you how to form and pour a cast of place countertop using the patented Z counter form system I'm sure you'll agree this is the easiest and fastest way to form a concrete countertop hi in this segment of video were going to walk you through the hole forming process at this point you can see that we've got the countertops removed were going to take our plastic Draper plastic over the tops of these two protective countertops or the cabinetry below from any splash as that were pouring the tops themselves and well start walking through this process here we have some plastic it should simply drape this over, and you like to do this before you put your aura Khans you don't have to tape it any wicking moisture through the door rock will be protected and we your cabinets down below as you said they're okay at this point we already have our dirt rocks cut for this piece, so we will just put it in place you can simply take a piece and scribe it over the top of this on the underside and cut it to fit from here well screw this piece down than well go ahead and continue to put down our forums well scribe our lap marks out take the measurements and cut our forming pieces when installing cement board to the cabinets the rough side should be kept up this will promote bonding of the concrete to the cement board attach the cement board to the cabinets with inch-and-a-quarter drywall screws the cement board should not extend past the cabinetry for this forming job we will be using the fancy edge profile we will now demonstrate how to prepare for an under mount sink opening carefully trace the sink template onto the cement board after this is completed remove the template and cut out the opening you can follow the same procedure for a drop-in sink if a drop-in sink were used you could use a piece of back wall form to block out the sink opening make sure to fasten all remaining cement board to the cabinetry at this point we've got our cement board all fastened down were going to go ahead and show you how to scribe out your marks, so you can take measurements to make your corners just simple as taking a piece of the forming system scribe out your corner each direction set it up flush this will give you an intersecting point which will then become your short point for your coroner allowing you to make your mite cut and make your coroners lineup into make them nice and flush the same on all four corners go ahead and scribe your marks for each direction here you are looking at an inside corner edge expert the two-piece kit also...